Avaya S8700 Maintenance Manual page 103

Avaya s8700 media server for ip connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Error Log Entries and Test to Clear Values

Table 8-343. MMI-PT Error Log Entries

Associated Test

Uplink error from pack

Busyout port PCSSpp

Software generated

Resource Loop-Back

test (#1111)

Uplink error from pack

Uplink error from pack

Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate

test's description, and follow its recommended procedures.

a. The customer endpoint connected on a conference sent too many

messages to the VSP-MCU in a specified amount of time. Check the

"status conference" forms to correlate which customer had the problem.

This is a customer endpoint problem and not a VSP-MCU problem.

b. This port has been busied out by the busyout port UUCSSpp command.

c. Indicates that the circuit pack has been removed or has been insane for

more than 11 minutes. To clear the error, replace or reseat the circuit pack.

d. This error occurs if the MMI circuit pack detects a DSP Error. Maintenance

software will reset the DSP when this error is received. This error is logged

for all 8 resources connected to this particular DSP. If this DSP continues

to fail sanity, a Minor alarm is raised. Replace the circuit pack.

e. This error occurs when the Resource Loop-around test (#1111) fails. Run

the long test sequence, and note the results of Test #1111.

Issue 1 May 2002

Test to Clear Value

test port UUCSSpp sh r 1

release port UUCSSpp

test port UUCSSpp sh r 3

Chapters

Table of Contents