Avaya S8700 Maintenance Manual page 186

Avaya s8700 media server for ip connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

Maintenance Object Repair Procedure
System Port Connectivity Test (#603)
This test is destructive.
This test verifies the capability to communicate between the PDATA and the Data
Line (TN 726B) ports of a System Port member. A System Port requires the
PDATA port and the Data Line port to be wired together. Failure of this test may
indicate faults with the wiring on PDATA port. Thus an off-board alarm is raised.
Since this test is applicable only to ports that are configured as a System Port, the
switch aborts the test if the port is not configured as a System Port.
The switch aborts this test if calls associated with the port are in progress. If the
ports are in use but tests must be run, the port can be busied out using the
busyout port UUCSSpp command. Release the port when the tests are done. If
a problem is fixed, the associated alarms will not be resolved until the port is
released.
Table 8-374. Test #603 System Port Connectivity Test
Error
Test
Code
Result
Description / Recommendation
11
ABORT
The Data Line port could not be setup for this test.
2100
ABORT
Could not allocate Data Line resources
1. Determine the Data Line port associated with the PDATA port.
2. Run test port UUCSSpp. If any of the Data Line port tests fail, resolve
3. If the problem persists, check the port admin and wiring
4. Verify that the Data Line port is not busied out (status data-module
1000
ABORT
The PDATA or Data Line port is in use for a call or maintenance tests are
already running on these ports.
1. Retry the command when the port is idle. The port may be forced to the
1005
ABORT
The configuration for this test is incorrect.
1. This is the expected test result for PDATA ports which have not been
2. If the PDATA port is supposed to be configured as System Port, make the
8-882
Issue 1 May 2002
these problems first.
extension) or not installed.
idle state by executing the busyout port UUCSSpp command. This
command is destructive causing every call and link associated with the port
to be torn down.
administered as a System Port.
necessary modifications on the port administration form change
data-module extension.
Continued on next page
555-233-142

Advertisement

Table of Contents
loading

Table of Contents