Avaya S8700 Maintenance Manual page 385

TBRI-PT (ISDN Trunk-Side BRI Port)
l. Error Type (2305) — The Remote Layer 3 Query failed. The test is
repeated every 15 minutes until it passes.
m. Error Type (3073) — A frame of information had to be repeated or deleted.
Slips usually occur when the received bit rate is not synchronized with the
TDM bus clock.
n. Error Type (3585) — The circuit pack detected an overflow of its receive
buffers. This error occurs only a system that switches the packet
implementation of the D channel over the TDM bus. This error indicates an
on-board problem related to the packet implementation of the TDM
D channel (R6.2 and higher).
o. Error Type (3586) — Each port can support up to three Terminal Endpoint
Identifiers (TEIs). Each channel on the port can request a TEI assignment
from the switch if it supports ISDN-BRI TEI assignment procedures. If
switch services gets a request for a fourth TEI on a port, it reports this
event to maintenance software and initiates TEI check procedures on the
port. Check to see if the correct number of channels are administered for
this port.
The user side supports automatic TEI assignment by the network. Both
fixed and automatic TEI assignment are supported on the network side.
p. Error Type (3587) — Service Profiler IDentifier (SPID) value is invalid or is
a duplicate of another SPID that is already initialized at Layer 3 on the port.
SPIDs are not used on the TN2185 circuit pack. However there will be
related events.
q. Error Type (3588) — The board receives D-channel data from the bus
faster than it can process the data. The FIFO RAM buffers overflowed.
This error occurs occasionally due to the statistical sizing of the buffers;
however, frequent occurrences may indicate a LAPD parameter mismatch
between the two endpoints of a packet-switched connection. Run the long
test sequence, and pay particular attention to the results of the Receive
FIFO Overflow test (#625).
r. Error Type (3589) — The BRI Port Local LAN Loop Around test (#618)
failed. Run the long test sequence, and pay particular attention to the
results of Test #618.
s. Error Type (3590) — An activated BRI port receives a frame containing a
DLCI over a D channel for which it does not have a translation. This error
normally indicates an off-board problem related to a state mismatch
between the far end and the switch. This error is logged only.
t. Error Type (3591) — The port is generating too many uplinks and is taken
out of service.
u. Error Types (3841–3942) —
cause values for Errors 3841–3942 that are recorded in the hardware error
logs. Unless otherwise stated, the cause values are D-channel events.
The aux data field shows which port caused the error.
555-233-142
Table 8-461 contains the received ISDN
Issue 1 May 2002 8-1081