Avaya S8700 Maintenance Manual page 644

Maintenance Object Repair Procedure
Table 8-555. VAL maintenance commands — Continued
Command
status link
status val-ip
netstat ip-route
list directory board
remove file
enable filesystem
disable filesystem
set ethernet-options
get ethernet options
set boot-image
get boot-image
8-1340 Issue 1 May 2002
Use this command to
Generate a status report about a specific administered Ethernet link.
(For VAL this means the administered Ethernet link.)
Generate an IP-related, MIB data status report.
Generate a report showing the status of the VAL IP routes on the VAL
circuit pack.
See the file contents of a VAL circuit pack by location.
Delete an announcement or firmware image file on a VAL circuit pack.
Begin an FTP session into a specific TN2501AP circuit pack.
End an FTP session into a specific TN2501AP circuit pack.
Manually or automatically set the Ethernet connection's parameters.
Generate a report about a specific Ethernet connection.
Direct the system to use 1 of 2 possible firmware image files on the
TN2501AP circuit pack.
View the two firmware image parameters on the VAL circuit pack.
Continued on next page
555-233-142