Avaya S8700 Maintenance Manual page 641

VAL-BD (Voice Announcements over LAN Circuit Pack)
Table 8-554. TN2501AP LEDs
LED Behavior
Red On solid
Green On solid
Amber On solid
Amber Fast flash
(100 ms on/
100 ms off)
Amber Slow flash
(200 ms on/
200 ms off)
LINK On/off
TRMT Intermittent
RCV Intermittent
100M On/off
FDX On/off
COL On/off
555-233-142
Description
Circuit pack failure or a major or minor on-board alarm
Firmware is self-downloading to the circuit pack or testing in progress.
Firmware is self-downloading to the circuit pack.
!
CAUTION:
You can lose the resident firmware image file if you reset the
circuit pack during firmware download. If this happens, FTP
a new firmware image file to the VAL circuit pack and
perform the Firmware download procedure again.
Occurs during circuit pack insertion or circuit pack reset which the
announcement files are being copied from FLASH to RAM. If you reset
the circuit pack during this time, your announcement files remain intact.
Flashes during autosave while copying announcement files from RAM to
FLASH.
!
CAUTION:
You can lose the announcements on the circuit pack if you
reset it during an autosave.
Active Ethernet link
Transmit
Receive
Off = 10-Mbps Ethernet connection
On = 100-Mbps Ethernet connection
Off = half-duplex connection
On = full-duplex connection
Off = no collisions detected
On = collisions detected
Continued on next page
Issue 1 May 2002 8-1337