Avaya S8700 Maintenance Manual page 397

TBRI-PT (ISDN Trunk-Side BRI Port)
Table 8-468. Test #1242 Level 1 Status Inquiry — Continued
Error Test
Code Result Description / Recommendation
4 FAIL Received a status of Level 1 Pending Activation, the NT1 has a loss of power
indicating a problem with the NT1.
1. Follow the manufacturer-recommended repair procedures for the NT1.
2. Execute the test port UUCSSpp command and review the results of the
PASS This test indicates that Level 1 is activated or that software has taken the port
out of service.
Layer 3 Query Test (#1243)
This test is nondestructive.
This test is used to check the application layer communications across the
in-service ISDN D channel. The test passes if a status enquiry message is
successfully sent, fails if the signaling link is down, and aborts if a query is already
running or there is an internal error.
Table 8-469. Test #1243 Layer 3 Query
Error Test
Code Result Description / Recommendation
1005 ABORT The test aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, a modem pool member or Music on Hold). This error
can be ignored.
1019 ABORT Test is already running.
1113 ABORT The signaling link is down.
1. Use the test port UUCSSpp long command to clear any errors which
2. Examine the results of Test #626, which is executed with the command. If
3. Escalate problem if BRI Layer 3 Query test continues to abort.
555-233-142
Level 1 Status Inquiry test to verify the repair.
prevent establishment of the signaling link.
this test aborts or fails, follow the repair procedure for the Signaling Link
Status test.
Continued on next page
Continued on next page
Issue 1 May 2002 8-1093