Avaya S8700 Maintenance Manual page 176

Maintenance Object Repair Procedure
2. If the port is a system port, enter status data-module ext. Record the
Data Line or PDATA port. If there is a connected port do the following:
a. Record the location of the connected port.
b. Run display port UUCSSpp for the connected port and record the
c. If the port is an announcement port, skip this step. Otherwise,
For each port and application located, check the alarm and error logs for
entries against these MOs. Follow repair procedures for MOs with log
entries. In situations where no connected ports were listed, test each
application link to ensure that more than one problem wasn't involved.
3. If the port is not a system port, enter status data-module ext and record
the connected ports, if any are present.
4. Locate the application affected by entering each command in column 4 of
the table below and checking the administered extension. The extension
might be used as a remote G3-MT or data terminal.
5. If the status data-module display indicates no connected ports, follow the
steps in
ports are working. If connected ports were displayed, enter display port
UUCSSpp using the connected port displayed. Record the associated
PDATA port.
6. For each port and application located, check the alarm and error logs for
entries against these MOs. Follow the repair procedures for MOs with log
entries. In situations where no connected ports were listed, test each
application link to ensure that more than one problem wasn't involved.
7. Enter list sys-link and look for a SAP type link with a port location that
matches the PDATA port. Check the alarm and error logs for entries
against the SYS-LINK. Follow repair procedures for SYS-LINK problems.
8-872 Issue 1 May 2002
identification and extension for the port.
determine whether the port's extension is administered as an
application extension. Do this by executing each command in
column 4 of the table below, checking the extension administered for
that application against the port's extension.
''Testing the System Port Pool'' above to verify that the system
555-233-142