Avaya S8700 Maintenance Manual page 169

OPS-LINE (DS1 Off-Premises Station Line)
Table 8-367. Test #36 Audit and Update Test — Continued
Error Test
Code Result Description / Recommendation
PASS Trunk translation has been updated successfully. The current trunk states kept
in the DS1 Interface circuit pack and switch software are consistent. If the
trunk is busied out, the test will not run but will return PASS. To verify that the
station is in-service:
1. Enter the status station command to verify that the station is in-service. If
2. Enter the release station command to put the station back into in-service.
3. Retry the test command.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use the list
2. If the board was found to be correctly inserted in step 1, issue the busyout
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should re-establish the linkage
555-233-142
the station is in-service, no further action is necessary. If the station is
out-of-service, continue to step 2.
config command, and resolve any problems that are found.
board command.
between the internal ID and the port. If this is not the case, dispatch to
check to ensure that there is a valid board inserted.
Continued on next page
Issue 1 May 2002 8-865