Avaya S8700 Maintenance Manual page 82

Maintenance Object Repair Procedure
MET Line Station Lamp Updates Test (#60)
For this test, the software lights the lamps on the terminal based on the status
record contained in the processor. The lamp updates run only if the station is
in-service.
Table 8-333. Test #60 MET Line Station Lamp Updates Test
Error Test
Code Result Description / Recommendation
1 ABORT This port may have been busied out.
1. Look in the Error Log for Error Type 18 (port busied out) for this port. If this
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
2 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
3 ABORT Station is in ready-for-service or out-of-service state. This may be due to wiring
or an unplugged or defective set.
1. Make sure terminal is connected and the wiring is correct.
2. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the station
2. If the port status is idle, then retry the command at 1-minute intervals up to
FAIL Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
PASS MET Line Station Lamp Updates completed successfully.
1. If complaints persist, investigate by using other circuit pack tests, and by
8-778 Issue 1 May 2002
error type is present, then release the port via the release station
<extension> command and run the test again.
extension of the port. Use the status station command to determine the
service state of the port. If the port is in use, wait until the port is idle
before testing.
5 times.
examining the station, wiring, and connections.
Continued on next page
555-233-142