Avaya S8700 Maintenance Manual page 62

Maintenance Object Repair Procedure
Table 8-324.
DSP Capacity Query Test (#1382)
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1-11 FAIL Some DSPs on the circuit pack have failed. The FAIL code is the number of
bad DSPs reported (TN802B only).
FAIL For the TN2302 only, the DSP failed. If it continues to fail, it will be taken out
of service.
PASS All 11 DSPs are functioning and in-service.
0 NO No board was detected by the test.
BOARD
1. Check the Error Log for wrong board (Error Type 125) or no board (Error
2. Check that the board is properly translated and inserted. If so, check for
3. Run the test again. If it fails, the circuit pack may be bad. Replace the
8-758 Issue 1 May 2002
Type 131). Resolve either of these issues, if applicable.
hyperactivity. If hyperactive, use the reset board UUCSS command.
circuit pack and retest.
Continued on next page
555-233-142