Avaya S8700 Maintenance Manual page 375

Avaya s8700 media server for ip connect configurations

Hide thumbs Also See for S8700:

Table of Contents

TBRI-BD (TN2185 ISDN Trunk-Side BRI)

Table 8-458. TBRI-BD Error Log Entries — Continued

Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate

test's description, and follow its recommended procedures.

a. The circuit pack stopped functioning or is physically removed from the

If the circuit pack is not in the system, insert a circuit pack in the same slot

as the error indicates. See note (g).

b. Transient communication problems between the switch and this circuit

pack. Execute the test board UUCSS command and refer to the repair

procedures for the

c. On-board hardware failure. Aux data values correspond to the following

detected errors:

Reset the circuit pack with the busyout board UUCSS and reset board

UUCSS commands. When reset, the circuit pack executes a set of tests to

detect the presence of any of the faults listed above. Detection of one of

these errors during initialization causes the circuit pack to lock-up and

appear insane to the system. See the repair procedure in Note (a).

Associated Test

This alarm logs approximately 11 minutes after removing the circuit

pack and/or the SAKI Sanity test (#53) fails.

''Control Channel Loop-Around Test (#52)'' on page

External RAM error

Internal RAM error

ROM Checksum error

Instruction set error

Test to Clear Value

Continued on next page

Issue 1 May 2002

Chapters

Table of Contents