Avaya S8700 Maintenance Manual page 485

TONE-BD (Tone-Clock Circuit Pack)
Notes:
a. Error Type 1
functioning or it was physically removed from the system.
If the circuit pack is not present in the system, insert a circuit pack in the
slot indicated by the error to resolve the error.
If the circuit pack is present in the system, it is faulty and must be replaced.
See the preceding section,
Further effects of this error depend on the system's reliability option.
.
Table 8-502. Effects of Tone-Clock Failures Depending on Reliability
Reliability
Option
Duplex
b. Error Type 23
physically installed. Installing the circuit pack will resolve the alarm.
c. Error Type 125
circuit pack is logically administered. To resolve this problem, either:
1. Remove the wrong circuit pack, and insert the logically administered
d. Error Type 126
log entry booted up without a Tone-Clock circuit, or with a one that cannot
communicate at all with the system. The error is logged five minutes after
the port network is restarted. If no circuit pack is present, install one of the
proper code. If there is a circuit pack present, replace it. See
the IPSI Circuit
e. Error Type 257
with this circuit pack. This error is not service-affecting and no action is
required.
f. Error Type 513
Replace the circuit pack using the procedure described in
IPSI Circuit
555-233-142
This error indicates the circuit pack totally stopped
NOTE:
The alarm is logged approximately 11 minutes after the circuit pack is
removed/SAKI Sanity test (#53) fails.
''Replacing the IPSI Circuit
Effects
EPN goes down.
The circuit pack has been logically administered but not
A wrong circuit pack is inserted in the slot where this
circuit pack.
or
Use the change circuit-pack command to re-administer this slot to
match the circuit pack inserted.
The port network specified in the PORT field of the error
Pack''.
his error indicates transient communication problems
This circuit pack has an on-board hardware failure.
Pack''.
Pack''.
''Replacing
''Replacing the
Issue 1 May 2002 8-1181