Avaya S8700 Maintenance Manual page 91

MMI-BD
Error Log Entries and Test to Clear Values
Table 8-337. MMI-BD Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (a) Any None
18 (b) 0 Busyout board UUCSS
217 (c) 0 None
257 (d) 65535 Control Channel Loop
test (#52)
513 (e) 4352 Uplink error from pack
to
4357
769 (f) Any MMI Synchronization
Status test (#1123)
1281 (g) Any Circuit Pack Restart test
(#594)
1538 (h) Any Software detected error
1793 (i) ANY TSI XTalk (#6)
2049 (j) Any TSI Loop (#1108)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
Notes:
a. The circuit pack stopped functioning or it was physically removed from the
system. The alarm logs approximately 11 minutes after the circuit pack has
been removed and/or the SAKI Sanity test (#53) fails.
If the circuit pack is in the system and the red LED is on, follow the
instructions for a red alarm in
Interpretation''. Also, see "Handling Common Port Circuit Packs."
b. This circuit pack has been busied out using the busyout board UUCSS
command.
c. There are more than four MMI circuit packs in the system. Remove the
circuit pack that generated the error in the error log by locating the slot
indicated by the error.
555-233-142
Alarm On/Off
Level Board Test to Clear Value
Any Any test board UUCSS sh r 1
MINOR ON
WARNING OFF release board UUCSS
WARNING ON
MINOR ON test board UUCSS r 3
MAJOR ON
MINOR ON
MINOR ON test board UUCSS l r 3
MAJOR ON test board UUCSS l r 3
''Circuit Pack LEDs'' in
Issue 1 May 2002
Chapter 6, ''LED
8-787