Avaya S8700 Maintenance Manual page 236

Maintenance Object Repair Procedure
Error Log Entries and Test to Clear Values
Table 8-393. Packet Interface Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (a) Any None
10 (b) 0 None
50 (c) 0 None
257 (d) Any None
513 (e) Any None
769 (f) Any Maintenance
Loop-around test
(#886)
1025 (g) Any Private Loop-around
test (#885)
1281 (h) Any None
1537 (i) Any Memory Checksum
test (884)
1793 (j) Any Memory Checksum
test (#884)
2049 (k) Any None
2305 (l) Any None
2561 (m) Any Active-Standby Peer
Link test (#888)
2817 (n) Any Read and Clear test
(#887)
3074, Any Maintenance
3073, Loop-around test
3072 (o) (#886)
3585 (p) Any None
3841 (q) Any None
1. Indicates that an alarm was raised but an associated error was not entered into the hardware error log due to a
momentary overload condition caused by a burst of hardware or software error reports. Run the long test
sequence. Refer to each appropriate test's description, and follow its recommended procedures.
2. A Packet Interface circuit on an active IPSI can only be reset if it has been taken out of service by background
maintenance software. A Packet Interface circuit on a standby IPSI can be reset independent of its service
state.
8-932 Issue 1 May 2002
Alarm On/Off
Level Board Test to Clear Value
Any ON test packet-interface Uc l r 2
MAJOR ON reset packet-interface Uc
MAJOR ON reset packet-interface Uc
MAJOR ON reset packet-interface Uc
MAJOR ON test packet-interface Uc s r 2
MAJOR ON reset packet-interface Uc
MAJOR ON reset packet-interface Uc
MINOR ON test packet-interface Uc l r 2
MINOR ON test packet-interface Uc l r 2
WARNING ON test packet-interface Uc r 25
test packet-interface Uc r 2
MINOR OFF test packet-interface Uc s r 2
MINOR/ ON test packet-interface Uc s
MAJOR
WARNING OFF test packet-interface Uc s r 2
WARNING OFF reset packet-interface Uc
MAJOR OFF reset packet-interface Uc
2
2
2
2
2
555-233-142