Avaya S8700 Maintenance Manual page 117

Avaya s8700 media server for ip connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

MODEM-PT (Modem Pool Port)
Table 8-347. Test #96 Modem Pool NPE Crosstalk Test — Continued
Error
Test
Code
Result
Description / Recommendation
2100
ABORT
System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
6000
ABORT
System resources needed to complete the test could not be allocated for the
digital section of the Modem Pool conversion resource. Ordinarily, this means
the conversion resource or other hardware used during the test was in use.
1. Wait 1 minute and attempt the test again.
2. If the same error occurs, use the status port command to determine
3. If the conversion resource is in use, and it is absolutely necessary to test it,
4. If the same error occurs while the conversion resource is idle, busyout both
5. If the test continues to fail or abort, replace the Pooled Modem circuit pack
6001
ABORT
System resources needed to complete the test could not be allocated for the
analog section of the Modem Pool conversion resource. Follow the test
procedures for the previous error code.
None
FAIL
The test failed. This error is internal to the Pooled Modem circuit pack and
does not involve external equipment or interfaces.
1. Busyout both of the TN758 Pooled Modem conversion resources on the
2. If the test continues to fail, replace the Pooled Modem circuit pack and
ANY
FAIL
The NPE of the tested port was found to be transmitting in error. This condition
will cause noisy and unreliable connections.
1. If the remaining ports are currently idle (amber LED is off), reset the circuit
2. If the test fails again, replace the circuit pack.
PASS
The port is correctly using its allocated time slots. Investigate user-reported
troubles on this port using other port tests and by examining station, trunk, or
external wiring.
555-233-142
whether the Modem Pool conversion resource is in use.
the call must be dropped by issuing a busyout port UUCSS command
against the conversion resource. Run the test again.
Modem Pool conversion resources on the TN758 Pooled Modem circuit
pack containing the conversion resource under test.
and retest.
circuit pack containing the failing conversion resource.
retest.
pack and repeat the test.
Continued on next page
Issue 1 May 2002
8-813

Advertisement

Table of Contents
loading

Table of Contents