Avaya S8700 Maintenance Manual page 441

TIE-DS1 (DS1 Tie Trunk)
Table 8-485. DS1 Tie Trunk Maintenance Error Log Entries — Continued
Error Aux
Type Data Associated Test
1281 Conference Circuit test
(#7)
1537 NPE Crosstalk test (#6)
1793 (i)
2305 (j) 50944 DS1 Tie Trunk Seizure
test (#136)
2562 (k) 16665
2817 (l) 52992
3840 (m) Any Port Audit and Update
test (#36)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
2. For TN767B vintage 8 or 9 circuit packs, a failure of Test #136 causes a subsequent failure of Test #7. Test #136
is part of the short sequence and generates off-board alarms. Test #7 is part of the long sequence and generates
on-board alarms. Before entering busyout, release, reset or test board long commands, check the vintage
number of the circuit pack with list configuration board UUCSS. If it is TN767B vintage 8 or 9, do not use the
above commands until first making sure that Test #136 passes via test board short. Otherwise, extraneous
on-board alarms may be generated.
3. This alarm will only be raised when the System-Parameter Country form has the Base Tone Generator field set
to 4 (Italy). This alarm will be a MINOR alarm unless 75% or more trunks in this trunk group are out of service,
then the alarm will be upgraded to a MAJOR alarm.
4. Major or Minor alarms on this MO may be downgraded to Warning alarms based on the values used in the set
options command.
Notes:
a. Error Type 1 — The DS1 Interface circuit pack detects a hardware error on
the DS1 tie trunk. This error can be caused by incompatible translations.
Make sure the parameters administered on the DS1 circuit pack form
match those administered on the far-end switch.
The Aux Data field indicates the following hardware error types:
57476
57477
57485
57487
555-233-142
Alarm
Level
MINOR
WARNING
MINOR
WARNING
MAJOR
MINOR
On-hook before wink
On-hook before ready to receive digits
Wink too short for valid signal
The timer expired while waiting for an off-hook signal from
the far end as a response at end-of-digits dialing. Check
the far-end switch for related problems.
On/Off
Board Test to Clear Value
ON test trunk grp/mbr l r 4
4
ON test trunk grp/mbr l r 3
4
test board UUCSS long
OFF
3
Continued on next page
Issue 1 May 2002
2
2
2
8-1137