Avaya S8700 Maintenance Manual page 64

Maintenance Object Repair Procedure
Table 8-325. TDM NIC Loop-Around Test (#1380) — Continued
Error Test
Code Result Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2801 ABORT The TN802B/TN2302 Media Processor board has not been administered on
the ip-interfaces form.
ANY FAIL The test did not detect the test tone through the looparound connection.
1. Test the tone-clock in the port network that contains the media processor
2. If the tone-clock is healthy, test the media processor board again.
3. If the test continues to fail, replace the media processor board.
PASS The board is functioning properly.
0 NO No board was detected by the test.
BOARD
1. Resolve either wrong board (Error 125) or no board (Error 131) issues, if
2. Check that the board is properly translated and inserted. If so, check for
3. Run the test again. If it fails, the NCE chip on board may be bad. Replace
8-760 Issue 1 May 2002
under test.
applicable.
hyperactivity (Error 1538). If hyperactive, use the reset board UUCSS
command.
the board and retest.
Continued on next page
555-233-142