Avaya S8700 Maintenance Manual page 390

Maintenance Object Repair Procedure
Table 8-464. Test #618 BRI Port Local LAN Loop Around
Error Test
Code Result Description / Recommendation
1015 ABORT The port is not out-of-service.
1. Use the status bri-port UUCSSpp command to determine the status of
2. If it is in use, wait until it is idle, and then use the busyout port UUCSSpp
!
1139 ABORT The Packet bus in the port network is out-of-service.
1. Follow the repair procedures for the Packet bus.
2. Run the test port long UUCSSpp command and verify the repair by
1141 ABORT The PKT-CTRL is out-of-service.
1. Follow the repair procedures for the PKT-CTRL.
2. Run the test port long UUCSSpp command and verify the repair by
2012 ABORT Internal system error
2100 Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The Loop-Around test has failed.
1. If the test fails repeatedly, attempt to reset the circuit pack with the
2. If the test fails again, execute test pkt P. If this fails, follow failure
3. If the tests in Step 2 pass, the problem is local to the BRI board. Replace
PASS The BRI Port Local LAN Loop-Around test passed.
8-1086 Issue 1 May 2002
the port.
command to place it in the out-of-service state and repeat this test.
CAUTION:
Since the busyout command is destructive, execution of this
command prior to the port being idle causes every call associated
with the BRI port to be torn down.
viewing the results of the BRI Port Local LAN Loop-Around test (#618).
viewing the results of the BRI Port Local LAN Loop-Around test (#618).
busyout board UUCSS and the reset board UUCSS commands if the
other ports on the board are idle.
procedures in the PKT-BUS section.
the trunk circuit pack.
Continued on next page
555-233-142