Avaya S8700 Maintenance Manual page 105

MMI-PT
Table 8-344. Test #1111 Resource Loop-Around Test
Error Test
Code Result Description / Recommendation
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Retry the command at 1-minute intervals up to 5 times.
2. Use the status conference command to determine whether there is an
1002 ABORT The system could not allocate time slots for the test. The traffic load on the
system may be very high, or time slots may be out-of-service due to TDM-Bus
errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003 ABORT The system could not allocate a tone detector for the test. The system is
oversized for the number of tone detectors present or some tone detectors are
out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals up to 5 times.
1004 ABORT The resource has been seized by a user for a valid call. Use the status
conference command to verify that there is a conference call active.
1. If there are no conference calls, retry the command at 1-minute intervals
2000 ABORT Response to the test was not received from the Tone Detector circuit pack
within the allowable time period.
1. If this result occurs repeatedly, reset the circuit pack, if the other ports are
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary resources to run this test. Abnormal abort.
1. Retry the command at 1-minute intervals up to 5 times.
555-233-142
active conference. If a call is active, the test cannot be run until the
conference call finishes.
repeat the test at 1-minute intervals up to 5 times.
up to 5 times.
idle. Reset the circuit pack by issuing the busyout board UUCSSpp and
the reset board UUCSSpp commands, followed by the release board
UUCSS command.
Continued on next page
Issue 1 May 2002 8-801