Avaya S8700 Maintenance Manual page 126

Maintenance Object Repair Procedure
Error Log Entries and Test to Clear Values
Table 8-351. M/T-ANL Error Log Entries
Error Aux
Type Data Associated Test
1
0 (a) 0 Any
1 (b) 41018 none
18 0 busyout port UUCSSpp
257 Any NPE Crosstalk test (#9)
513 Any Analog Port Sanity test
(#963)
769 Any Analog Port Digital
Loop-around test (#13)
3840(c) Any Hook State Inquiry test
(#566)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
Notes:
a. This error code appears in the Error Log only if the MTB circuit pack has
been removed since the Error Log was last cleared. Verify that the circuit
pack has been reinserted.
b. This error indicates a hardware failure on the Analog Port circuitry.
Replace the Maintenance/Test circuit pack if the above command does not
resolve the alarm.
c. This error indicates that call processing records did not agree with
on-board records for the hook state (on-/off-hook) of the Maintenance/Test
analog port. This error is not service-affecting and no action is required.
8-822 Issue 1 May 2002
Alarm On/Off
Level Board Test to Clear Value
Any Any test port UUCSSpp
MINOR ON test port UUCSSpp l r 3
WARNING OFF release port UUCSSpp
MINOR ON test port UUCSSpp l r 3
MINOR ON test port UUCSS01 r 2
MINOR ON test port UUCSSpp r 3
555-233-142