Avaya S8700 Maintenance Manual page 86

Maintenance Object Repair Procedure
MET Line Ringer Update Test (#62)
In this update, a "ringer on" or a "ringer off" message is sent to the firmware to
start and stop the ringer on the set.
Table 8-335. Test #62 MET Line Ringer Update Test
Error Test
Code Result Description / Recommendation
3 ABORT This port may have been busied out.
1. Look in the Error Log for Error Type 18 (port busied out) for this port. If
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use display port UUCSSpp to determine the station extension of the port.
2. If the port status is idle, retry the command at 1-minute intervals up to 5
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS Hybrid Station Ringer Update passed.
1. If complaints persist, investigate using other circuit pack tests, and by
0 NO The test could not relate the internal ID to the port. This could be due to
BOARD incorrect translations, no board is inserted, an incorrect board is inserted, or an
insane board is inserted.
1. Check to ensure that the board translations are correct. Use the list
2. Issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should re-establish the linkage
8-782 Issue 1 May 2002
present, release the port via release station <extension> and run the test
again.
Use status station to determine the service state of the port. If the port is
in use, wait until the port is idle before testing.
times.
examining the terminal, wiring, and connections.
config command, and resolve any problems that are found.
between the internal ID and the port. If this is not the case, check to
ensure that there is a valid board inserted.
Continued on next page
555-233-142