Avaya S8700 Maintenance Manual page 55

MEDPRO (Media Processor MAPD Circuit Pack)
Ping Test (#1379)
This test is nondestructive
This test verifies that the MedPro circuit pack can communicate to other nodes on
the LAN.
This test pings the gateway IP address as defined on the IP Interface form.
If the PING is successful, this test looks at the PING round trip delay. If a round
trip delay of greater than 4 seconds is reported, a separate error is logged.
Excessive round trip delays do not take the MedPro out of service.
Services can execute the standard PING command using the C-LAN board
address and MedPro IP address to see the actual round-trip delay. (See ping
commands).
This test is a nondestructive test. It runs because of in-line errors, during periodic
and schedule maintenance, and on demand.
Table 8-319. Test #1379 Ping Test
Error Test
Code Result Description / Recommendation
1, 2 ABORT Internal Error.
7 ABORT Destination unreachable.
2000 ABORT Response to the test was not received from the Media Processor circuit pack
within the allowable time period.
2012 ABORT Internal system error.
2100 ABORT The necessary system resources to execute the test could not be allocated.
2500 ABORT Internal system error.
555-233-142
1. Retry the command at 1-minute intervals up to 3 times.
1. Verify that at least one destination reachable through this port is up.
2. Repeat the test.
3. If the test still aborts, escalate the problem.
1. If this result occurs repeatedly, attempt to reset the circuit pack. Reset
the circuit pack by issuing the busyout board UUCSS and the reset
board UUCSS commands.
2. If this result occurs again, replace the circuit pack.
1. Retry the command at 1-minute intervals up to 3 times.
1. Retry the command at 1-minute intervals up to 5 times.
1. Retry the command at 1-minute intervals up to 3 times.
Continued on next page
Issue 1 May 2002 8-751