Avaya S8700 Maintenance Manual page 431

TDM-CLK (TDM Bus Clock)
System Technician-Demanded Tests:
Descriptions and Error Codes
Always investigate tests in the order presented in the table below when inspecting
errors in the system. For example, by clearing error codes associated with the
SAKI Reset test (#53), you may also clear errors generated from other tests in the
testing sequence.
Order of Investigation
SAKI Reset test (#53) (a)
Clock Health test (#46) (b)
Control Channel Loop-Around test (#52) (a)
Tone Generator Crosstalk test (#90) (c)
Tone Generator Transmission test (#40) (c)
Tone Generator Audit/Update test (#41) (c)
TDM bus Clock Circuit Status Inquiry test
(#148)
TDM bus Clock Slip Inquiry test (#149)(d)
TDM bus Clock PPM Inquiry test (#150)
TDM bus Clock Parameter Update test
(#151)
Board Type Check test (#574)
1. D = Destructive; ND = Nondestructive
Notes:
a. See ''XXX-BD (Common Port Circuit Pack)'' on page 8-1374
descriptions of these tests.
b. See ''TONE-BD (Tone-Clock Circuit Pack)'' on page 8-1173
description of this test.
c. See ''TONE-PT (Tone Generator)'' on page 8-1187
these tests.
d. Test #149 is not run on the TN2182.
555-233-142
Short Test Long Test
Sequence Sequence
X
X X
X X
X
X X
X X
X X
X X
X X
X X
X X
Issue 1 May 2002
Reset Board
1
Sequence D/ND
D
ND
ND
ND
ND
ND
ND
ND
ND
ND
ND
for
for a
for descriptions of
8-1127