Avaya S8700 Maintenance Manual page 274

Maintenance Object Repair Procedure
Table 8-408. Test #1275 SCOTCH Synchronous Loop-Around Test
Error Test
Code Result Description / Recommendation
1000 ABORT The port is in use or PPP link is connected.
1. Determine when the port is available for testing (status clan-port
2. The port may be forced to the idle state by executing a busyout port
1002 ABORT No TDM bus timeslots available for the test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
1963 ABORT Firmware indicates that the port is in use or ppp link is connected.
1. Determine when the port is available for testing (status clan-port
2. The port may be forced to the idle state by executing a busyout port
2000 ABORT Did not receive circuit pack test response within the allowable time period.
1. If this problem persists, reset the circuit pack (busyout board UUCSS,
2. If the problem persists, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2. Escalate if the problem persists.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
FAIL C-LAN circuit pack detected test failure.
1. If the problem persists, reset the circuit pack (busyout board UUCSS,
2. If the problem persists, replace the circuit pack.
PASS Port circuitry functioning properly.
8-970 Issue 1 May 2002
UUCSSpp).
UUCSSpp command.
NOTE:
This command is destructive, causing every call and link using the port
to be torn down.
UUCSSpp).
UUCSSpp command.
NOTE:
This command is destructive, causing every call and link using the port
to be torn down.
reset board UUCSS, and release board UUCSS).
reset board UUCSS, and release board UUCSS).
Continued on next page
555-233-142