Avaya S8700 Maintenance Manual page 368

Maintenance Object Repair Procedure
Notes:
a. Software requested a System Restart Level 3.
b. Software requested a System Restart Level 2.
c. Software requested a System Restart Level 1.
d. An error occurred during initialization.
e. Translation data was corrupted, so the system requested a Restart Level 3
to reload translation data from the Mass Storage System (MSS).
f. A reset system interchange or a scheduled server interchange failed.
The AUX Data indicates the cause of the failure. Consult the table in
note p. Use status spe to determine the current server status, and follow
the Standby SPE Maintenance procedures to resolve any problems that
are preventing the server interchange.
g. A reset system interchange health-override command has failed. The
standby server's state of health (SOH) would not allow a spontaneous
server interchange. Use status spe to determine the current server status,
and follow the Standby SPE Maintenance procedures to resolve any
problems that are preventing the server interchange.
h. Error 6001 indicates that an operating system error occurred on the active
server. The aux data gives the source of the error:
Aux-Data Value
5
6
i. Error 6002 indicates that an application error occurred on the active server.
See note (o) to diagnose the error using the aux data.
j. Error 6003 indicates that an application alarm occurred on the active
server. See note (o) to diagnose the error using the aux data.
k. Error 6100 indicates that an operating system error occurred on the
standby server. See error 6001 (i) to interpret the aux data.
l. Error 6102 indicates that an application error occurred on the standby
server. See note (o) to diagnose the error using the aux data.
m. Error 6103 indicates that an application alarm occurred on the standby
server. See note (o) to diagnose the error using the aux data.
8-1064 Issue 1 May 2002
Operating System Error Type
Software Abort
Server
Bus Error
555-233-142