Avaya S8700 Maintenance Manual page 50

Maintenance Object Repair Procedure
d. Error Type 125 - no Aux Data: The wrong circuit pack is inserted in the
slot where this circuit pack is logically administered.
1. Remove the wrong circuit pack and insert the logically administered
e. Error Type 257 - is associated with the Common Port circuit pack
maintenance test. See
8-1374
f. Error Type 1538 - is used to indicate hyperactivity on the circuit pack.
Hyperactivity on a circuit pack occurs when the angel is sending too many
CCMS messages uplink, 400 per ten seconds for the TN802B, to switch
software. The circuit pack will be taken out of service. See error Type
3999.
g. Error Type 2049 - indicates that the operating system is down. An attempt
is made to reset the board automatically. If the reset fails, the board is
probably bad and should be replaced.
h. Error Type 3841 - inconsistent downlink message. This error is not
service-affecting. No action is required.
i. Error Type 3999 - indicates that the circuit pack sent a large number of
control channel messages to the switch within a short period of time. If
Error Type 1538 is also present, then the circuit pack was taken
out-of-service due to hyperactivity. If Error Type 1538 is absent, then the
circuit pack was not taken out-of-service, but it has generated 50% of the
messages necessary to be considered hyperactive. This may be
completely normal during heavy traffic periods. However, if this error type
is logged when the circuit pack is being lightly used, it may indicate a
problem with the circuit pack or the equipment attached to it.
8-746 Issue 1 May 2002
circuit pack
or
Re-administer this slot to match the circuit pack inserted (change
circuit-pack).
''XXX-BD (Common Port Circuit Pack)'' on page
for details.
555-233-142