Avaya S8700 Maintenance Manual page 597

UDS1-BD (UDS1 Interface Circuit Pack)
Table 8-538. Test #1212 CPE Loop-Back Jack Test — Continued
Error Test
Code Result Description / Recommendation
PASS The CPE Loop-Back Jack test has successfully began executing. The test will
continue to run until the system technician enters the test ds1-loop UUCSS
end-loopback/span-test command or the release board UUCSS command.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board's translations are correct. Execute the add ds1
2. If the board was already administered correctly, check the error log to
3. If the board was found to be correctly inserted in step 1, then issue the
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port.
555-233-142
UUCSS command to administer the UDS1 interface if it is not already
administered.
determine whether the board is hyperactive. If so, the board was shut
down. Reseating the board will re-initialize it.
busyout board command.
Continued on next page
Issue 1 May 2002 8-1293