Avaya S8700 Maintenance Manual page 54

Maintenance Object Repair Procedure
IP Address Query Test #1371
This test is destructive.
The Media Processor has two interfaces for configuring the board: through the
NT PC interface, and the SAT via CCMS messages. For R10 DoLAN, the SAT via
CCMS is the only approved interface. However, the NT PC interface cannot
easily be disabled. It is possible that changes can be made via the NT PC
interface that cause the Media Processor board to be inconsistent with S8700 IP
Connect translations. The area of concern is the IP address, subnet mask, and
gateway translation.
This test sends the Media Processor the IP address, subnet mask, and gateway
translation (IP parameters). If the parameters do not match S8700 IP Connect
translations, the new values are written into the Windows registry, and the NT PC
asks the maintenance sub-system to reboot the board. The board goes through a
physical board removal and insertion.
When this test fails, it is an indication that an illegal change was made and the
customer should be notified. Also, writing the IP address parameters to the
registry requires NT to reboot. If the IP addresses match, there is no need to
update the registry and reboot NT.
Table 8-318. Test #1371 IP Address Query Test
Error Test
Code Result Description / Recommendation
ABORT Internal system error
2100 ABORT Insufficient system resources to run this test.
2801 ABORT Unable to find IP address data for this location. Verify that the board is
administered.
2807 ABORT The board is administered, but not enabled in the change ip-interfaces form.
FAIL The IP address, subnet mask, and gateway translation parameters do not
match S8700 IP Connect translations. After the new values are written into
the Windows registry, the NT PC must go through a reboot. The board goes
through a physical board removal and insertion.
PASS Translation data matches the Windows Registry.
8-750 Issue 1 May 2002
1. Retry the command at 1-minute intervals up to 5 times.
1. Retry the command at 1-minute intervals up to 5 times.
1. If the problem persists, replace the circuit pack.
Continued on next page
555-233-142