Avaya S8700 Maintenance Manual page 40

Maintenance Object Repair Procedure
NPE Connection Audit Test (#50)
The system sends the circuit pack's on-board microprocessor a message to
update the network-connectivity translation for its SCOTCH-NPE chip.
Table 8-302. Test #50 NPE Connection Audit Test
Error Test
Code Result Description / Recommendation
None ABORT System resources required for this test are not available.
2100
1. Retry the command at 1-minute intervals up to 5 times.
1019 ABORT The test aborted because a test was already running on the port.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS The circuit pack's SCOTCH-NPE chip has been updated with its translation.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Execute the add ds1
2. If the board was already administered correctly, check the error log to
3. If the board was found to be correctly inserted in Step 1, then issue the
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port.
8-736 Issue 1 May 2002
UUCSS command to administer the MAPD interface if it is not already
administered.
determine whether the board is hyperactive. If so, the board was shut
down. Reseating the board re-initializes it.
busyout board command.
Continued on next page
555-233-142