Avaya S8700 Maintenance Manual page 545

UDS1-BD (UDS1 Interface Circuit Pack)
Table 8-525. Test #135 Internal Loop-Around Test — Continued
Error Test
Code Result Description / Recommendation
1015 ABORT Ports on the UDS1 Interface circuit pack have not been busied out to
out-of-service.
1. Enter the busyout board UUCSS command to put every trunk or port of
2. Retry the reset board command.
1039 ABORT The UDS1 Interface circuit pack is providing timing for the system. Therefore, it
cannot be reset without major system disruption.
If the UDS1 Interface circuit pack needs to be tested, set the synchronization
reference to another UDS1 Interface circuit pack or to the IPSI circuit pack via
the following command sequence:
1. Issue the disable synchronization-switch command.
2. Next, issue the set synchronization UUCSS command.
3. Lastly, issue the enable synchronization-switch command.
2000 ABORT Response to the test request was not received within the allowable time period.
If Error Type 1538 is present in the Error Log, follow the maintenance strategy
recommended for this error type.
2012 ABORT Internal system error
1. Retry the reset board command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the reset board command at 1-minute intervals up to 5 times.
FAIL The UDS1 Interface circuit pack failed in the Internal Loop-Around test.
If the UDS1 connects to a T1 network facility or another switch:
1. Retry the reset board command at 1-minute intervals up to 5 times.
2. Enter the list measurement ds1-log UUCSS command to read the error
3. Verify that both endpoints of the DS1 link are administered using the same
4. Check the physical connectivity of DS1 Interface circuit packs and cable.
5. Replace the local UDS1 Interface circuit pack and repeat the test.
6. Contact T1 Network Service to diagnose the remote DS1 endpoint.
555-233-142
the UDS1 Interface circuit pack into the out-of-service state.
seconds measurement.
signaling mode, framing mode, and line coding.
Continued on next page
Issue 1 May 2002 8-1241