Avaya S8700 Maintenance Manual page 118

Maintenance Object Repair Procedure
Modem Pool Conference Test (#97)
This test is destructive.
The Modem Pool Conference test checks most of the switching and gain control
functions provided by the NPE circuit in the analog section of the conversion
resource. This test conferences a 1004-Hz tone through the NPE, looping it back
so that it can be verified with a Tone Detector circuit
Table 8-348. Test #97 Modem Pool Conference Test
Error Test
Code Result Description / Recommendation
ABORT System resources required for this test are not available.
1000 ABORT System resources required to run this test are not available. The port may be
in use on a valid call. Determine whether the port is available for testing.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions, or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present, or some Tone Detectors
may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals up to 5 times.
1004 ABORT The port has been seized by a user for a valid call. Determine whether the port
is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1020 ABORT The test did not run due to a previously existing error on the specific port or
because of a more general circuit pack error.
1. Examine the Error Log for existing errors against this port or the circuit
2000 ABORT The response to the test was not received in the allowable time period.
2012 ABORT Internal system error.
2100 ABORT System resources required for this test are not available.
2103 ABORT The system could not make the conference connection for the test.
1. Retry the command at 1-minute intervals up to 5 times.
8-814 Issue 1 May 2002
repeat test at 1-minute intervals up to 5 times.
pack, and attempt to diagnose previously existing errors.
Continued on next page
555-233-142