Tone-Pt (Tone Generator) - Avaya S8700 Maintenance Manual

Avaya s8700 media server for ip connect configurations

Hide thumbs Also See for S8700:

Table of Contents

TONE-PT (Tone Generator)

MO's Name (in

UU is the universal cabinet number (1 for PPN, 2 -64 for EPNs). C is the carrier designation (A, B,

C, D, or E).

Replacing the IPSI circuit pack requires a special procedure which is

described in

section also describes the LED display for this board.

The tone generator resides on the IPSI circuit pack and provides all system tones

such as dial tone, busy tone, and so on. If an active tone generator fails, its port

network may not have tones (see the

8-1190. For instance, a user may go off-hook and hear no dial tone.

This problem will affect only users on the same port network where the faulty IPSI

circuit pack resides. The system will be able to process certain type of calls (that

is, internal calls will succeed while outgoing calls will not).

The IPSI circuit pack also provides the clocks for the system and can serve as the

synchronization reference. Therefore, when resolving alarms on the IPSI circuit

pack, use the

Synchronization)'', and

documentation.

Initial Command To Run

test tone-clock UUC short

test tone-clock UUC short

release tone-clock UUC

''TONE-BD (Tone-Clock Circuit Pack)'' on page

''TDM-CLK (TDM Bus

''TONE-BD (Tone-Clock Circuit Pack)''

''Tone Generator Transmission Test (#40)''

''SYNC (Port-Network

Issue 1 May 2002

Full Name of MO

Tone Generator

8-1173. That

Table of Contents