Avaya S8700 Maintenance Manual page 140

Maintenance Object Repair Procedure
Hardware Error Log Entries and Test to Clear
Values
M/T-DIG Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (a) 41018 none
18 (b) 0 busyout port UUCSSpp
257 (c) Any NPE Crosstalk test (#9)
513 (d) Any Digital Port Sanity test
(#565)
769 (e) Any Digital Port Loop Around
test (#13)
3840 (f) Any Hook State Inquiry test
(#566)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
Notes:
a. This error indicates a hardware failure on a digital port's circuitry. Replace
the Maintenance/Test circuit pack if the alarm is not resolved by the
command above.
b. The port has been busied out via the busyout port UUCSSpp command.
c. This error indicates that Maintenance/Test digital port is talking on more
than just its assigned time slot. Replace the Maintenance/Test circuit pack.
d. This error indicates that the Maintenance/Test digital port has failed its
self-test. Since the Digital Port Sanity test runs only on port 2, but tests
both ports 2 and 3, both ports will be alarmed when the test fails. Note that
the command above indicates to test port 2, even if the error is logged
against port 3.
e. This error indicates that the Maintenance/Test digital port has been unable
to successfully loop data from a tone generator to a tone detector.
f. This error indicated that call processing records did not agree with
on-board records for the hook state (on-/off-hook) of the Maintenance/Test
digital port. This error is not service-affecting and no action is required.
8-836 Issue 1 May 2002
Alarm On/Off
Level Board Test to Clear Value
Any Any test port UUCSSpp
MINOR ON test port UUCSSpp l r 3
WARNING OFF release port UUCSSpp
MINOR ON test port UUCSSpp l r 3
MINOR ON test port UUCSS02 r 2
MINOR ON test port UUCSSpp r 3
555-233-142