Avaya S8700 Maintenance Manual page 392

Avaya s8700 media server for ip connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

Maintenance Object Repair Procedure
Table 8-465. Test #619 BRI Port Local TDM Loop Around — Continued
Error
Test
Code
Result
Description / Recommendation
1004
ABORT
The port has been seized by a user for a valid call. Use the status trunk
command for the trunks associated with this port and determine when the port
is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort and the port is idle, escalate the problem.
1005
ABORT
This test is not valid for this type of translation. Ports administered as ASAI or
ADJK cannot run this test because the B channels associated with the port are
not used by ASAI or Avaya Adjunct Links. This is a normal condition.
2000
ABORT
Response to the test was not received from the BRI-LINE circuit pack within the
allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit pack with the
2. If this result occurs again, replace the circuit pack.
2012
ABORT
Internal system error
2100
ABORT
Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2103
ABORT
The system could not make the conference connection for the test.
1. Retry the command at 1-minute intervals up to 5 times.
1, 2
FAIL
The TDM Looparound failed on one of the channels.
7, 8
FAIL
The Conference Circuit tests failed on a B channel.
1. If the test fails repeatedly, attempt to reset the circuit pack with the
2. If the test fails again, replace the circuit pack.
PASS
The BRI Port Local TDM Loop Around test passed.
8-1088
Issue 1 May 2002
busyout board UUCSS and the reset board UUCSS commands if the
other ports on the board are idle.
Error Code 1 — TDM Loop Around test failed on B1.
Error Code 2 — TDM Loop Around test failed on B2.
Error Code 7 — test failed on B1
Error Code 8 — test failed on B2.
busyout board UUCSS, the reset board UUCSS, and then the release
board UUCSS commands (if the other ports on the board are idle).
Continued on next page
555-233-142

Advertisement

Table of Contents
loading

Table of Contents