Avaya S8700 Maintenance Manual page 505

Avaya s8700 media server for ip connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

TSC-ADM (Administered Temporary Signaling
Connections)
Table 8-511. Test #604 TSC Heartbeat Inquiry Test — Continued
Error
Test
Code
Result
Description / Recommendation
1148
ABORT
The ADM TSC is enabled, but inactive (near end).
1. Disable and enable the ADM TSC.
2. Reissue the test tsc-administered command.
3. If the ADM TSC is still inactive, check the other nodes in the network.
1149
ABORT
The ADM TSC is disabled.
1. Enable the TSC, and see if the status indicates "active."
2. Reissue the test tsc-administered command.
3. If the TSC still disabled, remove the ADM TSC from the system.
1181
ABORT
Ran out of ADM TSC resources.
1. Reissue the test tsc-administered command at 1-minute intervals up to 3
1182
ABORT
The BX.25 link is down at the gateway.
1. Disable the ADM TSC.
2. Check the status of the gateway link via the status link link-num
3. Once the gateway link indicates an "in-service" state, enable the
4. Reissue the test tsc-administered command.
2000
ABORT
The Administered TSC is not responding to a TSC heartbeat inquiry.
1. Retry the test tsc-administered command at 1-minute intervals up to 3
2. If the problem continues to fail, obtain the status of the D channel or
3. Reissue the test tsc-administered command.
4. If the test fails, check the ADM TSC node on the other side of the network
555-233-142
times.
command.
Administered TSC.
times.
D-channel pair associated with the ADM TSC via the status sig-group
<group> command. If the D channel is INS (i.e., in-service) and the status
of the ADM TSC appears to be active, then disable and enable the ADM
TSC through administration.
NOTE:
To disable the ADM TSC, display the (administration) Signaling Group
Form via the change sig-group <group> command where <group>
refers to the number of the signaling group under which the suspect TSC
is administered. Change the "Enable" field to "n." To enable the ADM
TSC, change the "Enable" field to "y."
to verify that the ADM TSC is indeed active.
Continued on next page
Issue 1 May 2002
8-1201

Advertisement

Table of Contents
loading

Table of Contents