Installing The Cable Management System; Figure 18: Moving The Mounting Brackets On The Chassis - Juniper M10i Hardware Manual

M10i Internet Router Hardware Guide
6.
7.

Figure 18: Moving the Mounting Brackets on the Chassis

Installing the Cable Management System

The cable management system organizes and supports the PIC cables to prevent
damage.
To install the cable management system, follow this procedure (see
1.
2.
3.
4.
52
Installing the Cable Management System
Replace the screws that secure the mounting brackets to the chassis.
Reinstall the fan trays:
Grasp the handle on the faceplate of the fan tray with one hand and place
a.
the other hand under the unit to support it. Orient the fan tray so that the
thumbscrew is at the top of the tray.
Slide the tray into the slot.
b.
Tighten the thumbscrew to seat the fan tray firmly in the chassis.
c.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
"Preventing Electrostatic Discharge Damage"
Locate the cable management racks and appropriate screws in the accessory
box.
Slide the cable management rack into the slots at the front of the chassis.
Use a number 2 Phillips screwdriver to tighten the screws that secure the cable
management system to the chassis.
Figure 19
on page 140.
):