CHAPTER 7
Installing the M7i Router Mounting
Hardware
Installing the M7i Cable Management System
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Installing the M7i Cable Management System on page 45
Moving the Mounting Brackets on page 46
The cable management system organizes and supports the PIC cables to prevent damage.
To install the cable management system (see Figure 25 on page 45):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
1.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
Use a number 2 Phillips screwdriver to loosen the screws that secure the mounting
2.
brackets to the chassis, and remove the mounting brackets.
Locate the cable management racks and appropriate screws in the accessory box.
3.
Slide the cable management rack into the slots at the front of the chassis.
4.
Use a number 2 Phillips screwdriver to tighten the screws that secure the cable
5.
management system to the chassis.
Reinstall the mounting brackets.
6.
Figure 25: Installing the Cable Management System
M7i Cable Management System on page 25
M7i Chassis Description on page 6
45