Installing The M7I Into A Rack; Tools And Parts Required To Install The M7I Router Into A Rack; Installing The M7I Cable Management System - Juniper M7i Hardware Manual

CHAPTER 16

Installing the M7i into a Rack

Tools and Parts Required to Install the M7i Router Into a Rack

Related
Documentation

Installing the M7i Cable Management System

Copyright © 2019, Juniper Networks, Inc.
Tools and Parts Required to Install the M7i Router Into a Rack on page 109
Installing the M7i Cable Management System on page 109
Moving the Mounting Brackets on page 110
Installing the M7i Router Into the Rack on page 110
To install the chassis into a rack, you need the following tools and parts:
Phillips (+) screwdriver, number 2
Initially Configuring the M7i Router on page 129
M7i Chassis Description on page 11
M7i Chassis Lifting Guidelines on page 233
The cable management system organizes and supports the PIC cables to prevent damage.
To install the cable management system (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
1.
the strap to one of the ESD points on the chassis. Verify that the router is attached to
a proper earth ground.
Use a number 2 Phillips screwdriver to loosen the screws that secure the mounting
2.
brackets to the chassis, and remove the mounting brackets.
Locate the cable management racks and appropriate screws in the accessory box.
3.
Slide the cable management rack into the slots at the front of the chassis.
4.
Figure 29 on page 110):
109