Installing The M10I Cable Management System; Figure 22: Moving The Mounting Brackets On The Chassis - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide
Related
Documentation

Installing the M10i Cable Management System

52
All manuals and user guides at all-guides.com
Replace the screws that secure the mounting brackets to the chassis.
6.
Reinstall the fan trays:
7.
Grasp the handle on the faceplate of the fan tray with one hand and place the
a.
other hand under the unit to support it. Orient the fan tray so that the thumbscrew
is at the top of the tray.
Slide the tray into the slot.
b.
Tighten the thumbscrew to seat the fan tray firmly in the chassis.
c.

Figure 22: Moving the Mounting Brackets on the Chassis

Preventing Electrostatic Discharge Damage to an M10i Router on page 150
Tools and Parts Required to Install the M10i Router Into a Rack on page 55
Installing the M10i Router into a Rack on page 55
Installation Safety Warnings for M Series, MX Series, and T Series Routers on page 152
The cable management system organizes and supports the PIC cables to prevent damage.
To install the cable management system (see Figure 23 on page 53):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Locate the cable management racks and appropriate screws in the accessory box.
2.
Slide the cable management rack into the slots at the front of the chassis.
3.
Use a number 2 Phillips screwdriver to tighten the screws that secure the cable
4.
management system to the chassis.
Copyright © 2010, Juniper Networks, Inc.