Ipv6 Access-List Address - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IPv6 Commands

ipv6 access-list address

Adds IPv6 addresses to the specified IPv6 access list.
ipv6 access-list access-list-name address address/prefixLen [action {permit | deny}]
[redist-control {all-subnets | no-subnets | aggregate}]
no ipv6 access-list access-list-name address address/prefixLen
Syntax Definitions
access-list-name
address/prefixLen
permit
deny
all-subnets
no-subnets
aggregate
Defaults
parameter
permit | deny
all-subnets | no-subnets |
aggregate
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to delete the address from the access list.
•
The access-list-name should exist before you add multiple IPv6 addresses to the IPv6 access list.
•
The action parameters (permit and deny) determine if a route that matches the redist-control configu-
ration for the IP address is allowed or denied redistribution.
•
The redist-control parameters (all-subnets, no-subnets, and aggregate) defines the criteria used to
determine if a route matches an address in the access list.
•
Note that configuring the combination of redist-control aggregate with action deny is not allowed.
OmniSwitch CLI Reference Guide
Name of the IPv6 access list (up to 20 characters).
IPv6 address along with the prefix length to be added to the access list.
Permits the IPv6 address for redistribution.
Denies the IPv6 address for redistribution.
Redistributes or denies all the subnet routes that match the network
portion of the IP address as specified by the mask length.
Redistributes or denies only those routes that exactly match the IP
address and the mask length.
Redistributes an aggregate route if there are one or more routes that
match or are subnets of this address.
default
permit
all-subnets
June 2012 page 15-67