Cylinder Surface Transformation (Tracyl) - Siemens SINUMERIK 828D Commissioning Manual

Configuring cycles
7.5 Turning
[3] = 7
[4] = 3
[5] = 5
7.5.9

Cylinder surface transformation (TRACYL)

Function
Using the cylinder surface transformation function (TRACYL), you can machine the peripheral
surface of a turned part.
Setting up
General settings for cylinder transformation
MD10602 $MN_FRAME_GEOAX_CHANGE_MODE
= 1
MD24040 $MC_FRAME_ADAPT_MODE
Bit 0 = 1
Bit 1 = 1
Bit 2 = 1
MD28082 $MC_MM_
SYS‐
TEM_FRAME_MASK
Default, cannot be changed
When setting up the functions, you can take the following channel-specific machine data into
account:
MD24300 $MC_TRAFO_TYPE_3
= 512
= 513
= 514
122
Linear axis of the counterspindle
Main spindle
Counterspindle
Software option
You require the following software option in order to use this function:
"Transmit and peripheral surface transformation"
The actual total frame (work offsets) and when switching over geometry axes (selecting -
deselecting TRACYL) is recalculated.
System frame (SRAM)
without groove wall correction (without Y1 axis)
with groove wall correction (with Y1 axis)
with groove wall correction and Y1 correction
Frames when switching over geometry ax‐
es.
Adapting the active frames
Cylinder surface transformation, main spin‐
dle: Transformation 3
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate