Siemens SINUMERIK 828D Commissioning Manual page 446

Configuring cycles
7.1 Activating turning/milling/drilling/grinding technologies
= 5
= 6
= 7
= 8
= 9
= 10
= 12
= 13
Defining the direction of rotation
Enter the direction of rotation for the rotary axes that are not configured in a tool holder or a 5-
axis transformation via the following channel-specific machine data.
MD52207 $MCS_USAGE_ATTRIB[n]
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Additional settings
MD52005 $MCS_DISP_PLANE_MILL
= 0
= 17
= 18
= 19
MD52006 $MCS_DISP_PLANE_TURN
= 17
78
Counterspindle (turning)
Separate C axis of the counterspindle (turning)
Linear axis of the counterspindle (turning)
Tailstock (turning)
Steady (turning)
B axis (turning)
B axis in counterspindle (turning)
Transverse travel X of the counterspindle (turning)
Rotation around the 1st geometry axis (for rotary axes)
Rotation around the 2nd geometry axis (for rotary axes)
Rotation around the 3rd geometry axis (for rotary axes)
Direction of rotation is counter-clockwise (for rotary axis / C axis).
Displayed direction of rotation of the spindle / C axis for the M function M3 is counter-clock‐
wise
Inverts M3 / M4 (for spindles)
You must set this bit as for PLC bit DB38xx.DBX2001.6.
Display rotary axis as offset target for measurement
Offer rotary axis in the position pattern
Offer rotary axis to accept blank (on milling machines)
Spindle is not SPOS-capable
Rotary axis rotates around 1st geometry axis (only for position pattern)
Rotary axis rotates around 2nd geometry axis (only for position pattern)
Rotary axis rotates around 3rd geometry axis (only for position pattern)
Plane selection in the operator interface (cycle support for programming under "program‐
GUIDE G-Code")
G17 plane (default value)
G18 plane
G19 plane
G17 plane
Attribute of the axes in the channel
[n] channel axis number
PlaneSelectionMill
Plane selection turning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate