Siemens SINUMERIK 828D Commissioning Manual page 4

Preface
Target group
This documentation is intended for commissioning personnel.
The plant or system is readily assembled and wired. For the following steps, e.g. configuring
the individual components, the Commissioning Manual contains all necessary information or
at least references.
Benefits
The intended target group can use the Commissioning Manual to test and commission the
system or the plant correctly and safely.
Utilization phase: Setup and commissioning phase
Standard version
This documentation only describes the functionality of the standard version. Extensions or
changes made by the machine manufacturer are documented by the machine manufacturer.
Other functions not described in this documentation might be executable in the control
system. This does not, however, represent an obligation to supply such functions with a new
control system or when servicing.
Further, for the sake of simplicity, this documentation does not contain all detailed
information about all types of the product and cannot cover every conceivable case of
installation, operation or maintenance.
Technical support
Country-specific telephone numbers for technical support are provided in the Internet under
"Contact" (www.siemens.com/automation/service&support).
EC Declaration of Conformity
The EC declaration of conformity for the EMC directive can be found in the Internet under:
(http://support.automation.siemens.com/WW/view/de/10805517/134200)
4
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Commissioning