Siemens SINUMERIK 828D Commissioning Manual page 549

The following setting data is used to define in which axes and directions it is possible to calibrate
a tool probe.
SD54632 $SNS_MEA_T_PROBE_ALLOW_AX_DIR[k]
= 133
Decimal place
ONES
TENS
HUNDREDS
Example
If the general setting data SD54632 $SNS_MEA_T_PROBE_ALLOW_AX_DIR[k] has the value
123, the tool probe is calibrated as follows in the G17 plane:
● X in both directions
● Y only in plus direction
● Z only in minus direction
SD54631 $MNS_MEA_T_PROBE_DIAM_LENGTH[k]
= 0
General cycle machine/setting data for tool probe
MD51780 $MNS_J_MEA_T_PROBE_DIAM_RAD[k]
= 0
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Default value
1. Axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
2. Axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
3. Axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
Default value
Default value
7.9 Measuring cycles and measurement functions
Axes and directions for "calibration"
Effective diameter of the tool probe
for length measurement.
Effective diameter of the tool probe
for radius measurement.
Configuring cycles
181