Measuring In The Jog Mode - Siemens SINUMERIK 828D Commissioning Manual

Configuring cycles
7.9 Measuring cycles and measurement functions
7.9.3

Measuring in the JOG mode

Preconditions
You have already made the settings from the previous section "Measuring cycles and
measurement functions, general (Page 170)".
Workpiece measurement
For milling:
● The probe has been inserted in the tool spindle.
● The probe has been selected in the tool list as type 7xx (probe).
● The probe is activated as tool in the current NC channel.
Tool measurement
To measure tools, an appropriate probe must be located in the machine space so that this can
be reliably and safely reached with a tool in the spindle.
The following tool types are supported with the tool measurement:
● Milling technology: Tool types 1xx and 2xx
● Turning technology: Tool type 5xx, 1xx, 2xx
For the specified tool types, the tool lengths and the tool radii can be measured.
Setting general data
SD54782 $SNS_J_MEA_FUNCTION_MASK_TOOL
Bit 2
Bit 3
Bit 10
Bit 11
MD51784 $MNS_J_MEA_T_PROBE_APPR
_AX_DIR [i]
-2
-1
0
1
2
176
Activates the "Enable automatic tool measuring" function.
Selects the tool probe calibration data field, enable.
Selects the individual cutting edge measurement
Selects spindle reversal when calibrating in the plane
Negative direction, 2nd measuring axis
Negative direction, 1st measuring axis (default setting)
Positive direction, 1st measuring axis
Positive direction, 2nd measuring axis
Settings for the Tool measurement
in JOG input mask
Measuring in JOG: Approach direction in the plane to
the tool probe
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate