Siemens SINUMERIK 828D Commissioning Manual page 478

Configuring cycles
7.5 Turning
MD52216 $MCS_FUNCTION_MASK_DRILL
Bit 3
MD52218 $MCS_FUNCTION_MASK_TURN
Bit 2
Bit 5
Bit 6
MD52229 $MCS_ENABLE_QUICK_M_CODES
Bit 0
Bit 1
Bit 2
Bit 3
MD52230 $MCS_M_CODE_ALL_COOLANTS_OFF
= 9
MD52231 $MCS_M_CODE_COOLANT_1_ON
= 8
MD52232 $MCS_M_CODE_COOLANT_2_ON
= 7
MD52233 $MCS_M_CODE_COOLANT_1_AND_2_ON
= -1
SD55505 $SCS_TURN_ROUGH_O_RELEASE_DIST
= 1
= -1
110
Constant cutting speed referred to the diameter of the centering
= 0 Constant cutting speed referred to the diameter of the tool
= 1 Constant cutting speed referred to the diameter of the centering
Enable tailstock
Enable spindle control of the tool spindle via user interface
Enable Balance Cutting for two-channel stock removal
Coolant OFF
Coolant 1 ON
Coolant 2 ON
Coolants 1 and 2 ON
This machine data is used to define the M function for switching off the coolant; which is
output when the tool is changed.
This machine data is used to define the M function for coolant 1, which is output when the
tool is changed.
This machine data is used to define the M function for coolant 2, which is output when the
tool is changed.
This machine data is used to define the M function for coolant 1 and 2, which is output when
the tool is changed.
Specifies the distance, by which the tool is retracted from the contour when removing stock
from an outer corner. This does not apply to stock removal at a contour (default value).
The distance is internally defined.
Drilling function screen form
Turning function screen
Enable fast M functions
M code for all coolants OFF
M code for coolant 1ON
M code for coolant 2ON
M code for both coolants ON
Retraction distance for stock remov‐
al during external machining
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate