Cust_Multichan User Cycle; Commissioning Multi-Channel Machines With Programsync - Siemens SINUMERIK 828D Commissioning Manual

Marker
_M231
_M232
_M235
_M236
_M300
7.3.5

CUST_MULTICHAN user cycle

Function
The CUST_MULTICHAN cycle is used for multi-channel programming at lathes. It is called at
the start of the block when programming with blocks.
In the cycle, e.g. the master spindle is set to the spindle specified at the start of the block. The
return value (= 1) can be used to control whether the complete block is skipped.
CUST_MULTICHAN
Parameter
_S_NR
_RET
7.3.6

Commissioning multi-channel machines with programSYNC

This section describes the special features that you must observe during the commissioning
of a multi-channel machine with programSYNC (option) and ShopTurn.
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Action
Start of program (ShopMill program)
End of program header (ShopMill program)
End of program loop (ShopMill program)
End of program (ShopMill program)
Boring CYCLE86
Adapt the spindle to the tool position (SD55216 $SCS_FUNCTION_MASK_DRILL_SET
bit 6 = 1)
Meaning
Spindle number to which the master spindle is set.
Return value
= 0 The block is executed corresponding to the run-in mode.
= 1 The entire block is skipped.
Software option
You require the following software option in order to use the programSYNC function:
"programSYNC".
Configuring cycles
7.3 Manufacturer cycles
87