Siemens SINUMERIK 828D Commissioning Manual page 207

To check the maximum values of the three traces, press the "Cursors" softkey and position
the cursor on the associated trace to read the maximum values of the following quantities:
● Velocity
The cursor positioned over the trace shows that the attained maximum velocity is 36 m/min:
● Load
The cursor positioned over the trace shows that the attained maximum load is 58.52 %/min:
● Current
The cursor positioned over the trace shows that the attained maximum current is 10.53 A:
Summary
The maximum velocity of 36 m/min is attained with a maximum load of 58.52%. The "Load
(m_set/m_set_limit)" signal selection shows the percentage load of the active current limit. The
active current limit is: p0640 = [A rms value]
p0640 is limited to p0338 motor current limit / Mot I Max [A rms value] or r0209 drive current
limit / PU I Max [A rms value] depending on which value is lower.
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Tuning
6.4 Torque load
193