Siemens SINUMERIK 828D Commissioning Manual page 460

Configuring cycles
7.3 Manufacturer cycles
Block search with SERUPRO
To perform a fast block search, you must specify the following values:
MD22600 $MC_SERUPRO_SPEED_MODE
= 0
MD22601 $MC_SERUPRO_SPEED_FACTOR
= 10000
These values are also required for the simulation.
To prevent M-commands from being issued during the search with SERUPRO, you must set
bit 10 to "1" in the following machine data:
MD22035 $MC_AUXFU_ASSIGN_SPEC
Bit 10 = 1
MD22080 $MC_AUXFU_PREDEF_SPEC
Bit 10 = 1
To start the part program, set the following machine data:
MD10702 $MN_IGNORE_SINGLEBLOCK_MASK
Bit 16 = 1
MD10708 $MN_SERUPRO_MASK
Bit 0 = 1
Bit 4 = 1
To call the cycle for the SERUPRO process, set the following bit:
MD52212 $MCS_FUNCTION_MASK_TECH
Bit 5 = 1
You can set the selection options for the search modes separately in the following machine
data for programGUIDE and ShopTurn (single channel):
MD51024 $MNS_BLOCK_SEARCH_MODE_MASK_JS
Bit 0 = 1
MD51028 $MNS_BLOCK_SEARCH_MODE_MASK
= 33H
Bit 0 = 1
Bit 1 = 1
92
Program test with block search / dry run velocity:
Factor which is multiplied by the dry run feedrate.
No output during block search type 5 (SERUPRO)
No output during block search type 5 (SERUPRO)
Single block has no effect with SERUPRO
M0 has no effect with SERUPRO
Override has no effect with SERUPRO
Call block search function for SERUPRO.
Block search with calculation, without approach
Block search with calculation, without approach
Block search with calculation, with approach
Velocity for block search type 5
Velocity factor for block search type 5
Specification of the output behavior for the
user-defined auxiliary functions.
Specification of the output behavior for the pre‐
defined auxiliary functions.
Prevent single-block stop
Block change modes
Cross-technology function screen
Bit mask for the available search modes
(ShopMill, ShopTurn single channel)
Bit mask for the available search modes
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate