Siemens SINUMERIK 828D Commissioning Manual page 502

Configuring cycles
7.6 grinding
● CYCLE4077: Surface grinding, plunge grinding with measurement control
● CYCLE4078: Surface grinding with continuous infeed
● CYCLE4079: Surface grinding with intermittent infeed
References
For further information about oscillating cycles, please refer to:
Programming Manual, Production Planning; Chapter "Programming cycles externally" >
"Technological cycles"
Grinding function screen
MD51840 $MNS_GRIND_FUNCTION_MASK
Bit 0
MD52840 $MCS_GRIND_FUNCTION_MASK
Bit 7
SD54840 $SNS_GRIND_FUNCTION_MASK
SD55840 $SCS_GRIND_FUNCTION_MASK
Form-truing (CYCLE495)
SD55880 $SCS_GRIND_CONT_RELEASE_ANGLE
SD55881 $SCS_GRIND_CONT_RELEASE_DIST
SD55884 $SCS_GRIND_CONT_BLANK_OFFSET
134
Reference point for measuring the dresser/wheel is a work offset
= 0 Deselection of the work offset as reference point
= 1 Selection of the work offset as reference point
Retraction when form-truing with G1
= 0 Retraction when form-truing with rapid traverse (G0)
= 1 Retraction when form-truing with feedrate (G1)
This setting data is used to specify the angle of retraction from the contour during form-truing.
This setting data is used to specify the distance retracted in both axes during form-truing.
This setting data is used to specify the distance to the grinding wheel as of which the switch‐
over is made from G0 to G1 during form-truing.
Grinding cycles function screen
Grinding cycles function screen
Grinding cycles function screen
Grinding cycles function screen
Angle of retraction
Retraction distance
Blank allowance
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate